At the Lake Tools & Supplies Materials List Rings-n-Things Green Girl Studios C-Koop Beads Bead Inspirations 2) Olive green dyed wood 8mm saucer 6”) Black Greek leather 1.5mm 1) Turtle pewter pendant 1) Copper enameled 13/16” ball bead 6) Round Lampwork glass beads woodland glade 12mm Vintaj 1) 56x13mm rectangle bezel 1) 3” head pin 1) 4.75mm smooth 19ga jump ring 1) 7.25mm smooth 16ga jump ring 2) 9.25mm rib cable 15ga jump rings 1) 15mm classic lobster clasp Ranger Vintaj metal reliefing block steel bench block rubber dampening block 8oz ball pein hammer flush cutter round nose plier 2 chain nose pliers filigree shaping plier Vintaj patina: carnelian, earth, verdigris Vintaj glaze flat tip paint brush non-stick craft sheet heat it craft tool Beaducation 6mm letter stamp set screw down hole punch Other water paper towel scissors extra fine-tip black Sharpie Tip: To create a threaded end link, knot a 6 inch piece of 1.5mm Greek leather to a 9.25mm rib cable 15ga jump ring leaving approximately a ½ inch tail. Use chain nose plier to pull end of leather tail to tighten and secure knot. String the following onto leather cord; six 12mm large-holed round lampwork glass beads, one 8mm wood spacer bead, and one 13/16” enamel ball bead. Attach 15mm lobster clasp to a 9.25mm rib cable 15ga jump ring and close. Tie a tight knot with end of leather to previous jump ring with clasp. 28
30 Publizr Home