LONG-REACH SAWS Greenlee Hydraulic Long-Reach Chain Saws operate with Super Spool selector control for use on open and closed center hydraulic systems. Operating pressure of 1000-2000 psi and a flow range of 5-8 gpm. Cuts hard to reach areas from the aerial basket or from the ground. Insulated fiberglass extension tubes, tested to meet OSHA Regulation 1910.269. Safety features include: two-step trigger guard, and fully covered sprocket guard. Anti-kickback chain and automatic chain oiler. Rugged high torque gear motor. 13" cutting capacity. Available in three lengths. GR-43178 GR-38568 GR-43177 62.5" OAL 75" OAL 88.5" OAL Stanley Hydraulic Long-Reach Chain Saws are ideal for use by right-of-way crews, utilities, parks departments and grounds-keepers. Lightweight, they feature fiberglass poles for convenient handling in tight spots and automatic chain oiling for long, reliable service. The SN-CS28 is designed for HTMA Type II circuits and has an optimum flow of 8 gpm/30 lpm. The SN-CS25 is ideal for HTMA Type I circuits commonly found on bucket trucks where hydraulic circuit flow is often limited to 4-6 gpm /15-23 lpm. For greater versatility, the Stanley “Dual Spool” permits the user to adjust the saw to operate from either open or closed-center circuits. The SNCS25/CS28 use a low kickback, .325-pitch saw chain for added safety. The flow rating is easily changed by replacing the gear chamber and two gears. Both circuit flow systems are available in 75" and 90" Lengths. SN-CS25812 SN-CS25811 SN-CS28812 SN-CS28811 Type I, 75" OAL Type I, 90" OAL Type II, 75" OAL Type II, 90" OAL Reliable LR-SERIES Hydraulic Long-Reach Chain Saws long reach are intended for safely cutting and trimming trees from the ground or an aerial bucket. The powerful hydraulic drive motor can easily make cuts up to 13 inches in diameter. Available 62.5, 75 and 88.5 inches, the operator may easily reach areas not possible with a standard chain saw. The dielectric property of the fiberglass extension tube will reduce the chance of electric shock when used near an energized electric line. Other features include a trigger guard to prevent accidental movement of the chain, a covered sprocket guard, and a rubber collar hand stop. A quick set spool can be turned 180 degrees for closed center/open center operations. RL-LR-66.5 RL-LR-75 RL-LR-88.5 250 62.5" OAL 75" OAL 88.5" OAL Fax: 704•482•7349 POWER EQUIPMENT | HYDRAULIC
251 Publizr Home