POWER EQUIPMENT | HYDRAULIC Phone: 800•438•0671 PUNCH & POLE PULLER Huskie 35 Ton Hydraulic Steel Punch is designed to punch holes through 1/2” mild steel, aluminum and copper. The punched hole size is 1/16” larger than your bolt size. A stripper guide extends on either side of the ram to strip the material after punching. This hand-held unit will operate from any 10,000 psi hydraulic pumping source. Some uses include the punching of bus bars, tower iron, railing, I-beams and truck frames. Custom size punch and dies are available upon request. Oval and square sizes are also available. Consult factory for order information. The SH-270M and SH-270F come complete with four sets of punch and die sizes for 3/8”, 1/2”, 5/8” and 3/4” bolts and carrying case. HU-SH-270M 35 Ton, Punch Kit HU-SH-270M Tiiger Hydraulic Utility Pole Puller helps prevent personal injury associated with using a boom truck. At only 57 pounds, Tiiger’s pole puller is the lightest on the market. Reduces boom damage and maintenance cost resulting from pulling poles. Dramatically increases productivity and cuts time. Lifting capacity @ 50,120 pounds. Swivel fabricated with high yield strength steel in excess of 100,000 psi. Hook assembly manufactured with all stainless steel components. Base plate has the lowest possible center of gravity, minimizing tipping and provides wide distribution of force during a pull. Base plate is engineered with the strength to take the full force of the pole pulling and the flexibility not to crack under soft ground conditions. Low point of attachment lets you cut the pole closer to the ground. Back plate prevents chain roll-up and slippage. Swivel assembly pre-tensions the chain providing maximum lift per stroke. 2800 psi operating pressure. TI-4001D Tiiger, Pole Puller Kit TI-4001D 249
250 Publizr Home