353 ALIGNMENT Camber/Caster Tools 23220 & 23230 SLEEVE SETS • Ford changed the axle design in 2005 on their Heavy Duty trucks. These sleeves correct camber and caster on the new 4x4 F250 and F350 Super Duty trucks ASCOT NO. MFG. NO. 231-23220 23220 231-23230 23230 DESCRIPTION APPLICATIONS Complete Set FORD 4WD: 2005 & Up F250, F350 Super Duty; FORD RWD: 2005 & Up F250, F350 Solid Axle/Coil Spring Complete Set FORD RWD/4WD: 2005 & Up F450, F550 Coil Springs; CHEVY/ GMC 4WD: 2005 & Up Kodiak K4500, Topkick K5500 231-23220 FORD 2 & 4WD CAMBER/CASTER TRUCK SLEEVES • Sleeves are widely used to adjust caster and/or camber on many Ford 2WD/4WD trucks • To install, simply loosen and remove upper ball joint pinch bolt. Remove top snap ring if one is present • Sleeves allow for larger caster and camber changes which may be required on lowered and raised trucks • SET INCLUDES: Nine of the XRTM Camber/Caster truck sleeves ASCOT NO. MFG. NO. 231-23180 23180 DESCRIPTION APPLICATIONS Complete Set FORD 2WD:1987 & Up F350, 1987-96 F150, F250 (L/D), 198990 Bronco II, 1992 & Up E150, E250, E350, 1991-94 Explorer, 1989 -97 Ranger, 1999 & Up F250, F350 Super Duty; MAZDA 2WD:1991-97 Navajo, Pickup; Ford 4WD:1991-94 Explorer, 1990 - 97 Ranger; MAZDA 4WD:1991-97 Navajo, Pickup BALL JOINT PRESS SLEEVES • These specially designed sleeves make installation of the #23510-40 ball joints easy and profitable for the installer • Sleeves are designed to match the angle of the yoke on the axle housing to insure proper ball joint ASCOT NO. MFG. NO. 231-23580 23580 DESCRIPTION Bushing Sleeves For Ball Joints 23510, 23520, 23530, 23540 231-23580 TIE ROD ADJ WRENCH SET (4) • Adjust inner tie rods with this easy to use 4-piece wrench set • The wrenches feature spring loaded toothed jaws and sturdy grips to make toe adjustments quick and easy • This set of wrenches fits tie rods from 10.5 to 19mm • Individual tools are also available: 40850 fits 10.512mm rods, 40860 fits 12-14mm rods, 40870 fits 14-16mm rods, 40880 fits 16-19 mm rods ASCOT NO. MFG. NO. 231-40840 40840 DESCRIPTION Tie Rod Adj Wrench Set (4) 14 X 16MM SLOT PUNCH • Use an SPC slot punch to elongate a hole and get the change you need • Whether the OE left you an upset that won’t break out, didn’t give you a large enough slot, or didn’t give you a slot at all, use this high-quality tool to quickly and easily punch one • Made in the USA with tight tolerances and high quality bearings these punches are built to last ASCOT NO. MFG. NO. 231-74920 74920 DESCRIPTION 14 x 16mm Slot Punch 231-23230 231-23180 BUYER'S GUIDE ASCOT SUPPLY CORPORATION WARNING: For more information go to www.P65Warnings.ca.gov. SUPPLY CORPORATION ALIGNMENT
355 Publizr Home